Motherboard
A.Jumper setting
Ex. CMOS JUMPER
it is a 3 pins that is close on the CMOS battery
1 means it is the pin 1
if the setting of the pin is 1-2 NORMAL
pins 2-3 it means CMOS clear or Password Clear.
IDE1 Primary Master/Primary Slave
IDE2 Secondary Master/Secondary Slave
This is the IDE BELT
the color in the right side of the belt indiacates pin1.
![](https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEikq95dMula-pE_vjqSZMzIOcNSIkGLqqas2yfieNMXUMfXqfPD1uzwNIFxaGm-yWBQckXOwUNDLwNxpaaJ1D8PiEnim81JuDXsYSWtynWYNvZz2k4MTxwUV3YUp_ZarSkO9mrQlpH6UcTu/s1600/images+(6).jpg)
The color light Blue on the Board is the SATA port
![](https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEhnTu8Nj6119uOCRsMsi1Kna0Q5oMJXF9Ew0pB7xPexrm5YL6KrtgVFPWieyHAHX3wNLPsRFBVpu0jW8bZgj6j70us1Y9HknzwiQ6eBsvpV-ZV9l8cKwifpseP6vjRCgrwy8lt1sCdgibYR/s1600/images+%25284%2529.jpg)
This is the SATA Cable
Note: What is the difference between? ATA and SATA?
ATA- When you installed a hard disk on your board you had to set the jumper settings on it. either master or slave and sometimes it cannot be detected. other hard disk is not compatible on master or slave or the problem is on your ide belt or worst is on your ide connector.
SATA - thats why sata is now been out for new Mother boards it is auto detect to master or slave and fast file transfer.
Front Panel Connectors
Codes
1.PWR SW / AI_SW / PWR ON / PWR BT / PS-ON / POW ON / - indicates Power switch *2pins
2.RESET / RST - indicates Reset switch *2pins
3.PWR LED - Power Led *2pins
4.HDD LED / IDE LED - Hard disk Led *2pins
5.SPK / SPKR - Internal Speaker *2 to 4 pins.